Radio should be ON when up or downloading. Remove the driver and cable program, reboot PC reload driver SHOULD correct issue. If using aftermarket cable check to see contacts are CLEAN (*shiny) and fit TIGHTLY into the mike provisioning adapter (Mic jack) DO NOT touch ANY buttons while programming. Worst case, prior to programming RESET the radio to factory resets then load your amended program.
On Thu, Aug 19, 2021 at 2:03 PM Jim Unroe rock.unroe@gmail.com wrote:
Hi Eric,
On Thu, Aug 19, 2021 at 12:47 PM Eric Chopin echopin27@gmail.com wrote:
UV5XP.... However to get CHIRP to see the radio either in the 'Download from
radio'
or 'Upload to radio' ... with the cable plugged in to my PC or myMAC, the
radio must me switched OFF...then as I select 'Download or upload'as I
select 'OK' i must immediately switch ON my radio then CHIRP sees itand
proceeds. If I try to 'Download or upload' with the radio alreadyswitched
on I get the message 'The radio did not respond' as CHIRP cannot seeit
connected. Any suggestions? Thanks VE7ECJThat sounds like a programming cable/driver issue. Also, to program that radio you must choose...
Vendor: Radioddity Model: UV-5G
Jim KC9HI _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to cortchubby20007@gmail.com at cortchubby20007@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com