This is something I was thinking of opening a problem ticket on.  It is
confusing, obviously, to many to have the default and "no tone" setting
to be a tone.  In this case 88.5.  We use 88.5 on some repeaters locally
and having the "no setting" setting the same as "in use setting" both be
88.5 is confusing for a quick look at the grid.  I got confused, myself,
when going through the grid and had to go back to he repeater book to
figure out if these were really in use or not.  One used two different
tones and one was 88.5 and, once again, I had to go back and double
check and make sure if this was in use or "no tone".

I would also like to see a NONE setting in the Tone columns for a more
positive indication that there is no tone used here.

Another confusion is when you query the Repeater Guide, if no tone is in
use, it comes back 88.5 and you have to then investigate further to see
if this is real or "no tone" usage of 88.5.

All around confusing and since software is there to help us, it should
not impede progress by adding useless confusion when it is so easy to do
it "right" and show NONE when NONE is the correct setting rather than
duplicating a valid setting.

Even the stupid Wouxun software, for all its faults, does this
properly.  Seems like better software (CHIRP) could do at least that
good.  Right?

I have been a programmer for most of my life.  If I set a real entry as
the setting for NONE, I would have been fired!

Mike/W6XXX

On 7/23/2014 12:00 PM, chirp_users-request@intrepid.danplanet.com wrote:
> An entry in the ToneSql field is not required.
> If the Tone Mode selection is (none), the Tone and ToneSql fields are ignored.
> The 88.5 is a filler default.

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users