Hello

My name is Bruno Maire, HB9GHC and I would like to add the Yaesu FT-7100.

Chirp read from radio works over the serial port. Chirp read from and write to "FT-7100 Programmer" from "RT Systems" works over the serial port.

I am struggling with tone modes: TONE_MODES = ["", "Tone", "TSQL", "CTCSS Bell", "DTCS"] However "CTCSS Bell" is not known to chirp. There is an impact on other radios if I try to have it accepted with: mem._valid_map["tmode"] = TONE_MODES

What is the correct procedure to have "CTCSS Bell" as valid tone mode?

Best regards, Bruno