On 23 May 20, I said:
Attached patch adds support for the Retevis RT95 to the AnyTone778UV driver. Verified with help from Derek and Michele to run on the RT95. identification string is in the vendor software save image attached to the issue, but I've not been able to verify. That's enabled in the attached patch, is that the right approach, or would it be better left disabled for now?
Attached is a fresh version of the patch adding tested support for: * Midland DBR2500 * Retevis RT95 * CRT Micron UV
Supported features * Read and write memory access for 200 normal memories * CTCSS and DTCS for transmit and receive * Scan list * Tx off * Duplex (+ve, -ve, odd, and off splits) * Transmit power * Channel width (25kHz and 12.5kHz) * Retevis RT95, CRT Micron UV, and Midland DBR2500 radios
Unsupported features (known unknowns...) * VFO1, VFO2, and TRF memories * custom CTCSS tones * Full range of frequencies for tx and rx (limited to 144-148MHz and 430-450MHz * Band setting identification from radio * Any non-memory radio settings * Reverse, talkaround, scramble * busy channel lock out * probably other things too - like things encoded by the unknown bits in the memory struct
The test images haven't changed, but attached again for convenience.
Cheers, Joe